| Inspection Type |
Planned
|
| Scope |
Partial
|
| Safety/Health |
Safety
|
| Close Conference |
2018-07-18
|
| Emphasis |
L: FALL, P: FALL
|
| Case Closed |
2019-11-19
|
Violation Items
| Citation ID |
01001 |
| Citaton Type |
Serious |
| Standard Cited |
19260451 B01 |
| Issuance Date |
2018-10-25 |
| Current Penalty |
1140.0 |
| Initial Penalty |
2217.0 |
| Final Order |
2018-12-17 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1926.451(b)(1): Each platform on all working levels of scaffolds was not fully planked or decked between the front uprights and the guardrail supports as specified in paragraphs 1926.451(b)(1)(i)-(ii): a) On or about July 18, 2018, at the jobsite, an employee installing lath mesh from the second level of a frame walkthrough scaffold exposed to a 14 feet fall hazard in that the scaffold was not fully planked. |
|
| Citation ID |
01002 |
| Citaton Type |
Serious |
| Standard Cited |
19260451 C01 |
| Issuance Date |
2018-10-25 |
| Current Penalty |
1140.0 |
| Initial Penalty |
2217.0 |
| Final Order |
2018-12-17 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1926.451(c)(1): Supported scaffolds with a height to base width (including outrigger supports, if used) ratio of more than four to one (4:1) were not restrained from tipping by guying, tying, bracing, or equivalent means, as set forth in subparagraphs (i) - (iii) of this paragraph. a) On or about 07/18/2018, at the jobsite, employees were exposed to a fall hazard while standing/working from the metal frame scaffold with a height to base width ratio of 4.67 to 1. The scaffolding was not restrained from tipping. |
|
| Citation ID |
01003 |
| Citaton Type |
Serious |
| Standard Cited |
19260451 C02 |
| Issuance Date |
2018-10-25 |
| Current Penalty |
1140.0 |
| Initial Penalty |
2217.0 |
| Final Order |
2018-12-17 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1926.451(c)(2): Supported scaffold poles, legs, posts, frames, or uprights did not bear on base plates, mud sills or other adequate firm foundation: a) On or about July, 18, 2018, at the jobsite, employees working from a metal frame walkthrough scaffold exposed to a fall hazard in that the scaffold was missing mud sills at the footing. |
|
| Citation ID |
01004 |
| Citaton Type |
Serious |
| Standard Cited |
19260451 E01 |
| Issuance Date |
2018-10-25 |
| Current Penalty |
1140.0 |
| Initial Penalty |
2217.0 |
| Final Order |
2018-12-17 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1926.451(e)(1): Where scaffold platforms were more than 2 feet above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers, stairway-type ladders, ramps, walkways, integral prefabricated scaffold access, or direct access from another scaffold, structure, personnel hoist, or similar surface was not used for access: a) On or about July, 18, 2018, at the jobsite, employees were climbing the frame of the scaffolding for access/egress, exposing to a fall hazard. |
|
| Citation ID |
01005 |
| Citaton Type |
Serious |
| Standard Cited |
19260451 G01 |
| Issuance Date |
2018-10-25 |
| Current Penalty |
1140.0 |
| Initial Penalty |
2217.0 |
| Final Order |
2018-12-17 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1926.451(g)(1): Employees on scaffolds more than 10 feet (3.1 m) above a lower level were not protected from falling to that lower level by fall protection established in paragraphs (g)(1)(i)-(vii) of this section: a. On or about July 18, 2018, at the jobsite, an employee working from a frame walkthrough scaffold was exposed to a 14 feet fall hazard in that the scaffold was missing a guardrail at the working level. |
|
|
| Inspection Type |
Planned
|
| Scope |
Partial
|
| Safety/Health |
Safety
|
| Close Conference |
2018-07-16
|
| Emphasis |
L: FALL, P: FALL
|
| Case Closed |
2019-12-26
|
Related Activity
| Type |
Inspection |
| Activity Nr |
1330936 |
| Safety |
Yes |
|
| Type |
Inspection |
| Activity Nr |
1330953 |
| Safety |
Yes |
|
Violation Items
| Citation ID |
01001 |
| Citaton Type |
Serious |
| Standard Cited |
19260453 B02 V |
| Issuance Date |
2019-01-15 |
| Abatement Due Date |
2019-02-04 |
| Current Penalty |
1660.0 |
| Initial Penalty |
2772.0 |
| Final Order |
2019-01-30 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1926.453(b)(2)(v): A body belt with lanyard attached to the boom or basket was not worn by employee(s) working from an aerial lift: (a) On July 16, 2018, an employee installing wire mesh on the exterior wall of a commercial building using a Genie 40 High Reach aerial lift was not wearing body harness with a lanyard attached to the basket, exposing to a 15 feet fall hazard. |
|
| Citation ID |
01002 |
| Citaton Type |
Serious |
| Standard Cited |
19260405 G02 III |
| Issuance Date |
2019-01-15 |
| Abatement Due Date |
2019-02-04 |
| Current Penalty |
1940.0 |
| Initial Penalty |
3326.0 |
| Final Order |
2019-01-30 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1926.405(g)(2)(iii): Flexible cords were not used in continuous lengths without splice or tap: (a) On 07/16/2018, an extension cord used to power a DeWalt DWD110 3/8 VSR Drill was damaged in in that it was spliced and not properly repaired, exposing employees to electrical hazards. |
|
|
