Inspection Type |
Planned
|
Scope |
Partial
|
Safety/Health |
Safety
|
Close Conference |
2019-03-26
|
Emphasis |
L: FALL, P: FALL
|
Case Closed |
2023-11-06
|
Violation Items
Citation ID |
01001 |
Citaton Type |
Serious |
Standard Cited |
19260102 A01 |
Issuance Date |
2019-09-25 |
Current Penalty |
1363.8 |
Initial Penalty |
2273.0 |
Final Order |
2019-10-09 |
Nr Instances |
1 |
Nr Exposed |
1 |
Gravity |
5 |
FTA Current Penalty |
0.0 |
Citation text line |
29 CFR 1926.102(a)(1): The employer did not ensure that each affected employee uses appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation: a) On or about March 26, 2019, an employee not wearing eye protection while using a pneumatic stapler gun to install metal mesh for stucco application was exposed to struck-by hazards. |
|
Citation ID |
01002 |
Citaton Type |
Serious |
Standard Cited |
19260501 B13 |
Issuance Date |
2019-09-25 |
Abatement Due Date |
2019-10-07 |
Current Penalty |
1705.2 |
Initial Penalty |
2842.0 |
Final Order |
2019-10-09 |
Nr Instances |
1 |
Nr Exposed |
2 |
Gravity |
5 |
FTA Current Penalty |
0.0 |
Citation text line |
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b): (a) On or about March 26, 2019, at the front and left sides of a two story residential building, employees were exposed to a fall hazard of 10 feet, 7 inches while installing metal mesh on the walls without using a fall protection system. |
|
Citation ID |
01003 |
Citaton Type |
Serious |
Standard Cited |
19261053 B04 |
Issuance Date |
2019-09-25 |
Abatement Due Date |
2019-10-07 |
Current Penalty |
1705.2 |
Initial Penalty |
2842.0 |
Final Order |
2019-10-09 |
Nr Instances |
1 |
Nr Exposed |
1 |
Gravity |
5 |
FTA Current Penalty |
0.0 |
Citation text line |
29 CFR 1926.1053(b)(4): Ladder(s) were used for purposes other than the purpose for which they were designed: (a) On or about March 26, 2019, at the front of the residential building above the single car garage, an employee on the roof utilized an "A" Frame Werner 5 step ladder folded against the wall while installing metal wire mesh for stucco, exposing them to a 9 foot 4 inch fall to the ground. |
|
Citation ID |
01004 |
Citaton Type |
Serious |
Standard Cited |
19261053 B05 I |
Issuance Date |
2019-09-25 |
Abatement Due Date |
2019-10-07 |
Current Penalty |
1705.2 |
Initial Penalty |
2842.0 |
Final Order |
2019-10-09 |
Nr Instances |
2 |
Nr Exposed |
2 |
Gravity |
5 |
FTA Current Penalty |
0.0 |
Citation text line |
29 CFR 1926.1053(b)(5)(i): Non-self-supporting ladder(s) were not used at an angle such that the horizontal distance from the top support to the foot of the ladder was approximately one-quarter of the length of the ladder: (a) On or about March 26, 2019, employees were exposed to a 9 foot 8 inch fall while using a 24 foot Louisville metal extension ladder to access a 5:12 pitch roof. The ladder was set up 18 feet high and 6 feet away from the top support of the ladder. b) On or about March 26, 2019, employees were exposed to a 9 foot 8 inch fall while using a 20 foot Werner metal extension ladder to access a 5:12 pitch roof. The ladder was set up 13 feet high and 5 feet 9 inches away from the top support of the ladder. |
|
Citation ID |
01005 |
Citaton Type |
Serious |
Standard Cited |
19261053 B15 |
Issuance Date |
2019-09-25 |
Abatement Due Date |
2019-10-07 |
Current Penalty |
1363.8 |
Initial Penalty |
2273.0 |
Final Order |
2019-10-09 |
Nr Instances |
1 |
Nr Exposed |
2 |
Gravity |
5 |
FTA Current Penalty |
0.0 |
Citation text line |
29 CFR 1926.1053(b)(15): Ladders were not inspected by a competent person for visible defects on a periodic basis and after an occurrence that could affect their safe use: a) On or about March 26, 2019, at the front of a residential building car garage area, employees were exposed to falls while utilizing a Werner metal extension ladder (24 ft.) with missing foot assemblies for access and egress to a 5:12 pitch roof. |
|
Citation ID |
02001 |
Citaton Type |
Other |
Standard Cited |
19260503 A01 |
Issuance Date |
2019-09-25 |
Abatement Due Date |
2019-10-30 |
Current Penalty |
0.0 |
Initial Penalty |
0.0 |
Final Order |
2019-10-09 |
Nr Instances |
1 |
Nr Exposed |
2 |
FTA Current Penalty |
0.0 |
Citation text line |
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: a) On or about March 26, 2019, for employees installing metal mesh to a two story residential building from a 5:12 pitch roof from the leading edge without using a fall protection system. Employees exposed to a fall hazard of approximately 9 feet 4 inches. |
|
Citation ID |
02002 |
Citaton Type |
Other |
Standard Cited |
19261060 A01 III |
Issuance Date |
2019-09-25 |
Abatement Due Date |
2019-10-30 |
Current Penalty |
0.0 |
Initial Penalty |
0.0 |
Final Order |
2019-10-09 |
Nr Instances |
1 |
Nr Exposed |
5 |
FTA Current Penalty |
0.0 |
Citation text line |
29 CFR 1926.1060(a)(1)(iii): The employer did not ensure that each employee using ladders and/or stairways had been trained by a competent person in the proper construction, use, placement, and care in handling the ladders and/or stairways: (a) On or about March 26, 2019, for employees using 6-foot, 20-foot and 24-foot portable extension ladders to access the 5:12 pitch roof to install metal mesh onto the walls for stucco application. |
|
|